.png)
While troubleshooting a client who is unable to reach the default gateway you issue the netsh ip reset command. What will be the result of this command?
It sets the TCP/IP stack back to its default state on the client
:
Which interface counter or characteristic might you examine if you suspect that network packets are not arriving at their destination intact?
Cyclic Redundancy Check (CRC)
:
If host 1 has an IP address of 192.168.1.64, and host 2 has an address of 192.168.1.150, and both hosts have a subnet mask of 255.255.255.192, what will be the result in terms of communication between host 1 and host 2?
Neither will be able to reach the other
:
What is the most likely result of a duplicate IP address occurring on a LAN?
One or both systems with the duplicate address will lose connectivity
:
Which routing command can be used to display the current entries in a router’s table?
- show ip route
Issues with the Spanning Tree Protocol on a switch would most likely result in which type of problem or behavior?
Switching loops
:
Which type cabling might only support speeds of up to 100 Mbps?
Category 5
:
What symptom is most likely to be observed if a PoE device is receiving too much power?
Overheating
:
Address pool exhaustion on a LAN refers to which situation?
Not having enough addresses in a DHCP pool
.jpg)
