You have copied a new IOS image to your Cisco device. What command would you use to ensure the device boots from that IOS?
- boot system
What key sequence would you typically use while booting the Cisco device in order to start the password recovery process?
- CTRL-BREAK
What command in Windows would you use to view the pathway that your packet takes to a destination IP address?
- tracert
What command would you use to change the configuration register value in ROMMON mode to bypass the loading of startup-config?
- confreg 0x2142
What command would you use to delete the VLAN configuration file on a Cisco switch?
- del flash:vlan.dat
What command on your Windows system would you use to verify that you can communicate with the router with the IP address 192.168.2.1?
- ping 192.168.2.1
What command would you use to copy a new IOS image file from the TFTP server to your Cisco device?
- copy tftp: flash:
What command would you use to view a list of VLANs on the Cisco switch?
- show vlan brief
What hardware component is shown in the exhibit?
- Pin 1 to pin 4, pin 2 to pin 5
What command would you use to view the IOS image file that is installed on your Cisco device?
- dir flash:
You have rebooted the router after changing the configuration register value to 0x2142. What command would you use next before changing the password on the device?
- copy startup-config running-config
What command would you use to load the flash file system on a switch after interrupting the booting of the device?
- flash_init